Jump to content

DJM 900 Nexus and Innofader PNP - wire mod needed


odonov8
 Share

Recommended Posts

Hello All,

 

The Innofader PNP has an issue where an internal auto-switch is not compatible with the DJM 900 Nexus so needs to be disabled. This auto switch selects between balanaced and unbalanced curve control. Since the following mod will disable the switch, please set the Innofader PNP curve in the middle for proper operation. Otherwise one side will have a sharper curve than the other when you turn the curve dial.

 

To do this, simply remove the yellow wire from the side of the cable which plugs into the Innofader PNP main piece.

 

First lift up the wire with the mini screwdriver and pull out the wire at the same time.

 

DJM-900-mod1.jpg

 

When you are done it should look like this:

 

DJM-900-mod2.jpg

 

Don't forget when you are done to put electrical tape on the loose end so it doesn't short circuit inside the mixer.

 

DJM-900-mod3.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...