Jump to content

Innofader Pro in Technics SH-DX1200


odonov8
 Share

Recommended Posts

3/18/2016 edit: Now includes both Innofader Pro2 and Innofader Pro instructions:

 

INNOFADER PRO2 INSTRUCTIONS:

 

 

First locate the 2 wire cable in the Innofader Pro2 box. One wire is red and the other is black. Take one end of the cable, clip off the 2 pin connector, and strip the wire about 1/16", just enough so you can solder it. Solder the red wire to pin 8 of IC501...this is the +15V DC supply for the fader. Solder the black wire to pin 5 of IC501...this is the GND or ground reference for the DC supply.

 

Technics_SH-DJ1200_p1.jpg

 

Now locate adapter (13) which works for the SH-DJ1200. You will need to peel off the back so you can solder wires to the adapter. Please reorder the crossfader wires and solder to the connector as indicated in the below picture. Make sure pins 4 and 5 are shorted together, and don't forget to put the label back on when you are done!

 

Technics_SH-DJ1200_p2.jpg

 

Once you have completed the installation, it should look like this:

 

Technics_SH-DJ1200_p3.jpg

 

 

Special thanks to Ash Mukerjea for providing the following pictures:

 

innofader1.jpg

 

innofader2.jpg

 

innofader3.jpg

 

innofader4.jpg

 

innofader5.jpg

 

innofader6.jpg

 

innofader7.jpg

 

innofader8.jpg

 

innofader9.jpg

 

innofader10.jpg

 

innofader11.jpg

 

innofader12.jpg

 

innofader13.jpg

 

INNOFADER PRO INSTRUCTIONS:

 

Special thanks to Audey Bautista for contributing the images!

Do the wiring as shown here. You will need a soldering iron because this mixer doesn't have any power cables available in the crossfader section. At the same time, it's easiest to just connect the crossfader cables by soldering them to the non-VCA adapter board. Don't worry about the 2 unconnected wires because they are not used for the SH-DJ1200.
Technics_SH-DJ1200_wiring2.jpg

As far as the mechanical mounting, first drill two holes in the crossfader plate. Use a 5mm drill bit and spacing the holes 65mm apart with the holes symmetrical about the center. When you use the drill bit, only push the bit down until you get a 3mm diameter hole on the bottom. This way the Innofader Pro can easily mount using the included screws. Now when mounting the Innofader place the bracket above the mixer body rather than below so the Innofader stem has enough height.

NOTE: We have customer feedback that the Innofader in the below picture will operate in reverse. Please install the Innofader with the label facing the rear of the unit instead of the front of the unit to make the Innofader operate normally.
Technics%20SH-DJ1200%20bracket%20to%20mo

When you're all done it looks like this:

 

Technics%20SH-DJ1200%20stem%20with%20cap

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...