DJM-400 Installation Instructions Options

[odonov8]

For the Pioneer DJM-400, you need to purchase a special Innofader plus mounting kit specifically designed for this product. If you need to know more about this please email us.

First to start remove the screws as shown here. Note that the next few pictures have the Innofader at the crossfader; on the DJM-400 it will have the original fader installed. Sorry I was lazy here. Bear with me.


Once you remove all of the faceplate screws, you should be able to pop off the faceplate. Lift up the faceplate slightly and remove the flat cable shown here:


For ease of installation, lift the faceplate up, flip over to the left, and place down as shown here:


Remove the 2 screws on the front panel shown here. The crossfader plate should then drop down. Also make sure to disassemble the crossfader from the fader plate by removing the 2 mounting screws. All of the screws you need to remove here have red circles around them.


Before mounting the Innofader, prepare it as below. First mount the Innofader to the large bracket, label facing down, using either 5mm or 6mm flathead screws:


Mount the tab to the Innofader with the 2 hex screws and 2 lock washers. Use a 2.5mm hex wrench to tighten the screws


Connect the 6-pin crossfader cable to the Misc Adapter Board connecter J13 "NUMARK DIGITAL". Note the connector housing is already removed because the Pioneer cable header won't fit. This is completely normal and a special modification we did just for this product. Install the crossfader cable with the white wire closest to the blue Innofader cable wire.

Disconnect the Innofader cable from the Innofader itself and connect to the Misc Adapter Board. As shown in the picture, the misc adapter board blue wire goes to the Innofader grey wire and vice versa.


Place the Insulator tube over the Misc Adapter board and Innofader cable, and connect the Innofader cable back to the Innofader.


Place the Innofader with the bracket in the correct position on the Pioneer fader plate


Screw the Innofader with the bracket down to the Pioneer fader plate using the 8mm flathead screws included with the Innofader. Plug the flat cable back into the fader plate PC board. Make sure you tape down the insulator securely to keep a safe distance from power supply components in the Pioneer DJM-400. Note I was a bit lazy in this picture. Use more tape to be safe!!!


Put the faceplate back on the mixer and screw the front panel screws back into the fader plate. Note the drawing shows the screws only partially installed; make sure later to fully tighten the screws.


Screw the faceplate screws back into the fader plate. Note the drawing shows the screws only partially installed; make sure later to fully tighten the screws.


Finally install the remaining faceplate screws


And you're done!